I'm very satisfied
Soldering station works as expected. But has few downsides. 1. Soldering Iron stand is made up of plastic and the soldering Iron tip touches the back side of the stand and hence melts the plastic. 2. Two switches on the soldering stations are placed inverted and took a while for me to figure out its operation. This also cause confusion about the red LED on the front panel which displayes the heater status. If you are using both the heater gun and the soldering hand simultaneously, then you don't know for which one has triggered the RED LED i.e which one is heating. 3. Two buttons named "CAL" in front of the stations are just dummy buttons and doesn't do anything, but causes confusion about the calibration operation. 4. Rotary knobs on the front panel to calibrate the temperature is of low quality and had 2 pointers/notch on it. Other than these problems, soldering station works fine. It takes 1 min to heat up to 300 degree Celcius. and heating gun, works as expected.