Stickers already applied, but in a bad manner, bubbles under sticker and stickers half off again. Stuffed into two boxes, fuselage was forcefully pushed in the box so complete back is squeezed now, altogether very bad impression
Took a LONG time to arrive. Packaging was sturdy. Even though, aircraft fuselage and one wing had impact marks not caused by post handling. No instructions about assembly at all, not that it's a problem but lacking CG data? Accompanying hardware good quality. Paint yourself as decals provided are 'cheesy'. Overall a project to spend some time on.
In addition to initial comments.. a pretty crappy build. Very little space in the rear fuselage to put a decent ESC and receiver. With an 1800 to 2200mah battery it HAS to go into the narrow part of the fuse for CG reasons which is quite tiny really. Design is not good as only two magnets hold the cockpit/canopy to the upper rear fuse which really is not enough holding strength. With the wings epoxied to the main fuselage they flex too much too. This model I am underwhelmed with. I wanted to 'soup it up' with performance parts but I can't due to space limitations. Even then above 50mph during aeros it'll come apart. Not really recommended as kit version. Perhaps as pnp with low cost, low performance supplied parts might satisfy some beginner builders. Best of luck.